The ___________method of drilling can only be used for preliminary investigations for foundations.

A contractor needs to purchase 25 lengths of structural steel angle, 3 1/2 x 2 1/2 x 3/8. Each piece of 20" long. The total weight to be purchased is _______________________ pounds. Select the closest answer.

Any discrepancies on the plans or specifications or changes the architect or owner wish to make after the plans and specifications have been issued, but before bids are turned in, are incorporated in the ____________ .

The average life expectancy of tires in construction work is from _______ to ________ hours.

A masonry unit that does not meet standards or specifications and has been rejected is known as ___________.

A minor arch with a maximum span of 6 feet and a load not exceeding 1000 lb per foot is typically referred to as a ______________________ arch.

According to the Construction Specifications Institute (CSI) divisions, subdivision 105500 denotes ______.

Based on the above house plan, the total roof area is ____________________ sqft. Select the closest answer.

A defect in workmanship is found 18 months after a project is completed. A ________bond would cover the repair.

____________ standard bricks are required to build an ft x 20 ft wall . Select the closest answer.

A contractor has to excavate a drainage swale that is 200' long, 16' wide and has a depth of 2' with the ends vertical. If the soil to be removed is mud, the total volume of material to be removed from the job site would be _____________ cyd. Select the closest answer

Which of the following is not an advantage to using Tilt-up wall panel construction?

The principal objective of construction scheduling is to manage all of the following resources used in the construction process except for ______________.

If a contractor regularly operates within an area that requires a permit bond, the cost of this bond should be expensed _____________.

Once a loan is approved and accepted, ____________ is (are) NOT considered a closing cost (s).

Modular face bricks with a nominal brick size of 2 2/3" x 4" x 8" are to be used to face a 2,500 square foot wall without headers. _________bricks will be required for this job. Select the closest answer.

Some advantages to be realized when a is used to excavate is that it digs straight, vertical side walls (in soil which will stand), it cuts a level floor, and it reduces hand trim to a minimum.

A shelf or ledge formed by projecting successive course of masonry out from the face of the wall, pier or column is a _____________________ .

In an ordinary building foundation work, the most common type of pile to be used is _______________.

The weight of 150' of 2-1/2" x 2-1/2" x 3/16" steel angles is __________ pounds. Select the closest answer

If 450 bank cubic yards of dry sand is to be excavated, the number of loose cubic yards that will be excavated is ________cubic yards. Select the closet answer.

One of the easiest and most frequently used methods of computing grading cuts or fills for a plot plan that shows contours is the ___________________________ method.

When renting non-tractor equipment, the __________is usually responsible for the cost of repairs due to normal wear and tear.

________ is the amount of time for an activity, obtained by subtracting its early start (ES) from its late start (LS) or early finish (EF) from its late finish (LF).

A diesel backhoe has a 175 HP engine. The estimated fuel consumption for the backhoe is _______gallons per hour. Select the closest answer.