The weight of 150' of 2-1/2" x 2-1/2" x 3/16" steel angles is __________ pounds. Select the closest answer

The type of cost estimate where the estimator starts an entirely new cost estimate based on the items of work identified in the contract specifications and drawings is called the ____________.

According to Walker's Estimator's Reference Book, 8" light weight concrete block has an R value of _________.

Another reference name for a Bar Chart is a _________________.

The convenience outlet symbol is defined to be a ________.

Which of the following is NOT an advantage of renting or leasing construction equipment?

The typical dead weight of a ¾ inch piece of structural plywood is __________ lbs.

Plans and elevations are usually drawn at no less than _______ .

Any discrepancies on the plans or specifications or changes the architect or owner wish to make after the plans and specifications have been issued, but before bids are turned in, are incorporated in the ____________ .

A wall built of the withes of masonry units, separated by an air space, and tied together is known as a (an) _______________ .

The principal objective of construction scheduling is to manage all of the following resources used in the construction process except for ______________.

Well point systems are typically used for dewatering excavations. For specific applications, the general contractor should ___________________ .

Most working drawings for building construction are based on ____________.

Welded steel fabric with a 6"x6" mesh of 6 gauge wire will weigh _____ pounds per 100 sq. feet

___________determines the quality requirements on a project during the process of bidding.

The type of mortar recommended to be used for stone foundation walls is _________________________ .

2600 L.F. of 2 x is ____________board feet. Select the closest answer.

A method of construction for walls that greatly reduces the investment in large quantities of forming material is known as _______________ construction. In this method, the wall panels are cast on the ground and then raised into position.

The typical swell factor for an average blasted rock is ____________________ %.

When excavating sandy clay/moist loam using a hydraulic tractor (crawler) backhoe with a 1-1/4 cubic yard bucket, an average of cubic yards can be excavated per 8-hour day. Select the closest answer.

A vertical plane represented by an orthographic projection of the outside building is a (an) _________________ .

A _____________contract allows the owner control over the selection of his general contractor.

Modular face bricks with a nominal brick size of 2 2/3" x 4" x 8" are to be used to face a 2,500 square foot wall without headers. _________bricks will be required for this job. Select the closest answer.

One of the easiest and most frequently used methods of computing grading cuts or fills for a plot plan that shows contours is the ___________________________ method.

The federal government, under the _________ , requires that a contractor furnish two separate bonds, one for performance and one for the payment of labor and materials.